Perific's products are fully compatible with Autel. Get access to data regarding your property's total power output and optimize your power usage.
The Perific solution for Autel:
Easy to install
Perific's products are installed with your charging station from Autel.
All properties
Perific is compatible with all properties, ranging from 16A to 2,5kA.
Optimize
Optimize your power usage and save money.
The EV charger is one of the most energy-consuming units in modern homes today. The Perific system is therefore compatible with charging stations connected to Autel.
The Monitor is an advanced solution for dynamic power management. We offer advanced monitoring of your electricity usage.
Perific reports the available power output to Autel. This can help you balance the power curve and possibly saving you unnecessary electric costs.
By monitoring the property's total power output you are able to keep the main fuse from getting triggered.
Perific's solution is compatible with all properties, ranging from small private homes 16A to building complexes 2,5kA. In addition, Perific is specifically designed to work regardless if you have a new or old electrical meter.
Perific monitors and communicates the property's total power output in real-time. Perific constantly communicates the data to Autel, creating the best opportunity for power optimization.
Information about the property’s power consumption is all available in the Perific app. The app makes it easier than ever for you to load balance your EV charger as well as identify KPIs and optimize your power usage.
The Autel system decides how many charging stations that can be used per site.
Perific informs Autel about the available charging capacity in real-time. Perific doesn't communicate directly with the charging station when it comes to Autel.
Autel MaxiCharger AC Wallbox is supported.
After the monitor has been offline for about 2 minutes, we start sending the predefined offline values to Autel.
Currently not available.
Currently not available.
Currently not available.
Perific's products are often installed at the same time as your EV charger. However, it is possible to install Perific's products after the charger is installed.
The current sensors are connected to the three phases of the property: L1, L2, and L3. For Perific to work properly, the sensors are ideally installed as close to the distribution station as possible. With Perific One, installation via the P1/RJ12 port is also available.
The installation is usually performed by a certified electrician.
If you couldn't find the answer to your question, you are always welcome to contact us.